Minimig – Amiga clone, hand soldered

I decided to build a Minimig – a clone of Amiga, it can act as Amiga 500, 500+ or 600, with up to 4MB total RAM.

The interesting thing is that it uses an actual 68000 CPU – clocked at 7 or 50MHz in Turbo mode.

Other proprietary Commodore chips are implemented in FPGA.

I also built an ARM controller board – which replaces the small PIC micro, serves as SD card interface and feeds the FPGA with initial bitstream.

I’ve also included 3 hardware mod’s – additional 2MB RAM (sitting on top of original chips), SD high speed interface and lastly – joint stereo/separate stereo switch.

This was my first time soldering such a fine pitch (and expensive) chip – wasn’t all that hard.

pins.JPG

FullSizeRender.jpg

arm.JPG

running.JPG

wb.JPG

Leave a Reply